D-link Airplus Xtreme G Dwl-2100ap Drivers For Mac

D-Link AirPlus Xtreme G wireless routers are used for high-speed Internet. In fact, they provide data transfers of up to 108 Mbps. You can configure your router to keep your wireless network secure. Not securing it is the equivalent of leaving the network wide open for anyone to access.

With the new AirPlus Xtreme G DWL-2100AP Wireless Access Point, D-Link sets a new standard for wireless access points. With the D-Link 108G enhancement, the DWL-2100AP can achieve wireless speeds up to 15x in a pure D-Link 108G environment through the use of new wireless technologies such as Packet Bursting, Fast Frame, Compression & Encryption.

Step 1

Unlike most access points, the DWL-2100AP provides data transfers at up to 108 Mbps in Super G mode when used with other D-Link AirPlus Xtreme G products. The 802.11g standard is backwards compatible with 802.11b devices.
The D-Link AirPlus Xtreme G DWL-G520 PCI Adapter is a wireless PCI adapter featuring the very latest in advanced wireless silicon chip technology to deliver incredibly fast data transfer in the 2.

Connect a cable from your modem to one of the ports on the back of the router.

Step 2

Type the router's IP address -- 192.168.0.1 --into your browser's address bar and hit 'Enter.' This will take you to the log-in page for your router.

Step 3

Type 'admin' as the username and type 'password' as the password. Click 'OK.'

Step 4

Change the SSID to a term that is familiar to you. You can use anything that you can easily remember for this setting.

Step 5

Select 'Enabled' to set WEP as the security setting and assign the level of encryption you want -- 64-bit or 128-bit.

Step 6

Select a key type -- either HEX or ASCII and enter a pass code that you can remember, such as orange1234. Click 'Apply' to complete your router's configuration.

Disconnect the Internet cable you connected in Step 1.

Tip

You will need the SSID and WEP keys to set up your wireless clients.

Warning